ThingMagic Mercury xPRESS Platform v1.7 - Manual (Page 54)

WiFi Module
A D I V I S I O N O F T R I M B L E
54 Using the Optional Modules

confINCLUDE_CLI_CMD_WIFLY_FACTORY_RESET

This is used to include the Console command for RN-171 factory reset

The CLI commands syntax: wifly-factory-reset

confINCLUDE_CLI_CMD_WIFLY_FIRMWARE_UPDATE

This is used to include the Console command to update firmware in the RN-171

The CLI commands syntax: wifly-firmware-update
type is .mif or .img
Configuration Settings
To use RN-171 with xPRESS Reader, enable configuration for output mechanism in
conf_xpress_reader.h as ENABLE_OUTPUT_WIFLY
The WiFi module (RN-171) requires the following configuration settings to support all its
modes of operation.
 WiFi Config
 SSID
 Auth type
 Password
 DHCP/Static IP Config
 DHCP Mode ON/OFF
 Port Number
 IP Address
 Netmask
 Gateway
 DNS Address

Remote/Host Config

Hostname / DNS name
 Host IP Address