Xpress platform contents, Hardware – ThingMagic Mercury xPRESS Platform v1.7 User Manual
Page 18
xPRESS Platform Contents
A D I V I S I O N O F T R I M B L E
18
Quick Start Guide
xPRESS Platform Contents
The xPRESS development platform is shipped as an open system allowing maximum
flexibility in changing hardware configuration and peripherals. This chapter explains how
to assemble the development platform and operate the RFID Sensor demo program over
the USB interface. Once successful, you may want to run this application over one of the
optional module interfaces and add GPS location sensing. If so, consult the
section. Use caution when configuring the hardware.
Note
Always turn off the power and unplug the power cord before changing
hardware configuration and peripherals.
Hardware
Processor Motherboard with one module (either M6e, Micro, or Micro-LTE)
AC Power Adapter with international adapter plugs
Two USB cables
Antenna cable which converts MMCX to Reverse-TNC
The xPRESS Development Platform comes with an AC power adapter, two USB cables,
one antenna cable, and one of the UHF RFID modules shown in the picture. The red