SINGER XL-580 - Manual (Page 78)

76
PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP
1. Turn hand wheel counter clockwise (toward you) until the
needle comes to its highest position.
1
ATTACHING AND REMOVING
EMBROIDERY HOOP
1. Raise presser foot and needle, and push up lever (A) of
HPEURLGHU\IRRWZLWK\RXU¿QJHUDQGSDVVHPEURLGHU\KRRS
under it.
¿ To remove, pull the hoop forward to slide it out from
underneath the embroidery foot.
2. Slide the hoop onto the embroidery unit from front to back
until it clicks into place.
¿ To remove, press the release lever and slide the hoop
towards you.
NOTE: Before attaching small hoop or endless hoop, turn on
power switch to move the carriage to embroidering
standby position.
(A)
2
1
Hoop mounting plate
Plaque de montage de cerceau
Placa de montaje de aro
Carriage
Chariot
Carro
Hoop release lever
Levier de retrait du cerceau.
Palanca de liberación del aro