Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 7)

1-3. Setting Up Your Scale
1. Place the scale on a suitable weighing surface (Refer to
Best Conditions For
Weighing of next page) and turn the adjustable feet until the spirit level shows that
the scale is level.
2. Plug in the AC adapter. The AC input requirements could be l00, 120, 220, 230 or
240 Volts (50/60Hz) depending on where used, so, please check that the adapter is
correct. Ground the scale to avoid a problem with the static electricity.
‰ The display comes ON
After running through a self-check that will show various segments, the weighing
display will appear.
1111111
ЖЖ ЖЖ
9999999
ЖЖ
-------
ЖЖ
self-check
ÆÆ
3. Please leave the scale with the AC adapter connected for at least thirty minutes
before use. We call this situation "warm up".
If desired: press the STANDBY/OPERATE key to turn the display off.
Remember that the scale will always be warmed up as long as the AC adapter is
connected. This keeps the scale always ready for use.
Best Conditions For Weighing
‰ The scale must be level (check the spirit level on the scale).
waiting for weighing
data to become
stable
STABL
. 888888 0
SFV
: : ( , * + 7 N J
1213456789 0.000
$ 8 8 : J
12314567 0.00000
ZERO TOTAL M+
TARE
ENTERED SCALE
ACAI
SAMPLE
TOO LIGHT
Spirit level
Leveling foot
Earth terminal
Weighing pan
Remote scale slot
AC adapter jack
OP-02 slot
OP-03/04 slot
Calibration switch cover
RS-232C