Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 47)

Pcs On the ACAI
Weighing Pan Addition Range 60 63~123
10 13~27 70 73~139
20 23~50 80 83~153
30 33~71 90 93~167
40 43~90 100 103~300
50 53~107 over 200 203~493
STABLE
ACAI
STABLE
ACAI
STABLE
ACAI
As you add, the ACAI
indicator will be ON
as long as you are in
range.
When you stop adding
and the display
becomes STABLE, the
ACAI indicator will blink.
After the new unit
weight is calculated,
the indicator will
disappear,
3. Continue adding pieces within the ACAI range until you have reached a sample size
as large as the largest number of pieces that you will be counting.
‰ When you have added the maximum number of pieces required, remove the
sample pieces and start your counting job.
11-3. ACAI Manual Operation
‰ The ACAI procedure can also be controlled manually. The ACAI will not recalculate
the unit weight until the ENTER key is pressed (as long as it is at the proper time
and the guidelines in the ACAI notes have been followed).
‰ The ACAI manual mode is controlled by F-Function f-02-01, set at “2”.
‰ To start ACAI manual operation, the unit weight must be registered and the samples
still on the weighing pan.
1. Add pieces within the nearest ACAI range
(refer to table in the previous section). The
ACAI indicator will stay ON as long as you
are within the ACAI range.
2. Wait until the display becomes stable and press the ENTER key.
When the new unit weight is calculated, the indicator will blink for a moment and
disappear.
3. Continue adding pieces within the ACAI range until you have reached a sample size
as large as the largest number of pieces that you will be counting.
‰ When you have added the maximum number of pieces required, remove the
sample pieces and start your counting job.
. 88888 21
SFV
A : ( , * + 7 N J
1213456789 2.331
$ 6 $ 0 8 8 : J
12341567 111.000
ACAI