Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 19)

3-4. Unit Weight By KEYBOARD
1. Three UNIT WEIGHT BY LED’s should be blinking at this
point, if not, press the RESET key to clear any unit weight.
lf you are going to use a tare container, place it on the
weighing pan and press the TARE key
to tare the container.
2. Press the KEYBOARD key.
The unit weight display and the
ENTER key LED will blink.
3. Use the 0 Æ 9 and
. 10-key pad to display the
unit weight.
‰ If you hit the wrong key, press
the C key to clear and start
again.
(Example of a unit weight 32g)
4. Press the ENTER key.
The unit weight 32g will have
been entered.
If the unit weight entered is too light, “
lo ut”
(low unit weight) will be displayed, and you
will be returned to step 3.
5. You may now begin counting operations for
pieces of the same weight.
KEY-
BOARD
STABL
. 8888810
SFV
: : ( , * + 7 N J
1123456789 0.000
$ 6 $ 0 8 8 : J
1231456789012 0. 4567890123456
7
TARE
ZERO M+ SCALE TOTAL ENTERED
. ------ 0
SFV
: : ( , * + 7 N J
1213456--- 0.000
$ 6 $ 0 8 8 : J
12341567 32.0000
ENTER
. ------0
SFV
: : ( , * + 7 N J
123456-0-- 0.000
$ 6 $ 0 8 8 : J
12314567l lo ut
‘ Ñbeep, beepÒ ‘
0 Æ 9
. 8888850
SFV
: : ( , * + 7 N J
1213456789 0.000
$ 6 $ 0 8 8 : J
123415678901 32. 4567890123456
7
678
&'( #$%
/01 2345
,-. )*+
9:;< %