Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 18)

Desired Sample Size Not Using The
SAMPLE
Key
1. Three UNIT WEIGHT BY LED’s should be blinking at this
point, if not, press the RESET key to clear any unit weight.
lf you are going to use a tare container, place it on the
weighing pan and press the TARE key.
Be sure the weight display is “
0”.
2. Place sample pieces on the
weighing pan (or in the tared
container).
The weight of the pieces will be
displayed.
3. Use the 0 Æ 9 10-key pad
to enter the sample size of the
pieces you placed.
‰ If you hit the wrong key, press
the C key to clear and enter
again. (Example of setting a
sample size of 20)
4. Press the ENTER key.
The display will show dashes for
a moment while calculating the
unit weight. After a moment the
display will show the count, total
weight and unit weight.
If the "Add Sample" displays again, then the
sample size is not enough for accurate
counting - add the additional number of sample
pieces.
5. You may now begin counting operations for
pieces of the same weight.
. 88888 20
SFV
: : ( , * + 7 N J
1123456789 2.220
$ 6 $ 0 8 8 : J
12345167 111.000
. 888882 0
SFV
: : ( , * + 7 N J
1123456789 2.220
A $ G G 8 : J
12134567 0.00000
STABL
. 888881 0
SFV
: : ( , * + 7 N J
1213456789 0.000
$ 6 $ 0 3 8 : J
12341567 0.00000 4567890123456
7
TARE
ZERO M+ SCALE TOTAL ENTERED
Ñ Blinking Ò
If weight isn’t zero, press the TARE.
0 Æ 9
. 88888 20
SFV
: : ( , * + 7 N J
1123456789 0.000
A $ G G 6 D P S O H
123456789012345678901234567
678
&'( #$%
/01 2345
,-. )*+
9:;< %
.-------
SFV
: : ( , * + 7 N J
1213456 -------
A $ G G 6 D P S O H
123456789012345678901234567
ENTER
TARE