Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 20)

3-5. Unit Weight By ID Number
1. If there are no unit weight’s stored in memory, refer to “
5-1. Store Unit Weight by
ID Number”.
Three UNIT WEIGHT BY LED’s should be blinking at this point, if not, press the
RESET key to clear any unit weight.
2. Press the ID key.
"
id-000000" will be displayed with
С000000Т blinking.
‰ If you have been using the unit
weight by ID number, its ID number
stays displayed and blinks.
3. Use the 0 Æ 9 10-key pad to
display the ID number.
‰ If you hit the wrong key, press the
C key to clear and start again.
(Example of ID number "
123456")
4. Press the ENTER key.
The count display will show "
0" and
the scale will recall "12g"
previously entered as the unit
weight of ID 123456.
If there is no unit weight entered for the ID
number you tried to recall, “
no id” will be
displayed, and you will be returned to step 3.
5. You may now begin counting operations for
pieces of the same weight.
. ------ 0
SFV
: : ( , * + 7 N J
1234561--- 0.000 4568 id-123456
6 $ $ 0 8 8 : J
12345617 12.0000
ENTER
. ------0
SFV
: : ( , * + 7 N J
1234561--- 0.000 4568id - no id
6 $ 0 8 8 : J
1234567l0.0000
‘ Ñbeep, beepÒ ‘
ID.
STABLE
. 8888810
SFV
: : ( , * + 7 N J
1234516789 0.000 4578 id-000000
6 $ 0 8 8 : J
12345670.00000
TAR
SCALE ZERO TOTAL M+ ENTERED
0 Æ 9
. 8888850
SFV
: : ( , * + 7 N J
1213456189 0.000 4578 id-123456
$ 6 $ $ 8 8 : J
123415610.00000
678
&'( #$%
/01 2345
,-. )*+
9:;< %
‰ “id-00000” is a special memory area. It always holds the last
Unit Weight entered.
‰ When you register a unit weight , it is automatically placed in the
ID “
id-00000”.
‰ If you clear the unit weight by pressing the RESET key, it can
be recalled by recalling the ID “
id-00000”.