Rice Lake 920i Based Truck In/Out System - Manual (Page 22)

18 920i Based Truck In/Out Weigh Program
4.3 Weigh
1. To perform a single weighment, select the Weigh softkey. The truck ID entry screen is displayed.
Figure 4-9. Truck ID Entry Screen
2. Use the up/down, right/left navigation keys, to scroll through the alpha-numeric menu to enter the truck ID
(shown in Figure 4-9).
3. Move the cursor back down to the Truck ID entry and press enter to save the truck ID. If no tare has been
entered, it will prompt for a tare (Figure 6-7).
4. Enter the Customer ID, Product ID, and Project ID as the series of prompts come up.
Press enter without keying in an ID for any of the above as it is not necessary to enter those. If Auto-prompt is
set to No in the Supervisor System menu this will not prompt through all IDs and the user will have to press
individual softkeys to select customer, project, product IDs separately.
5. The following screen is now displayed.You can select customer or product from the menu softkeys if they have
not been entered.
Figure 4-10. Customer Selection
Home Cancel
10/22/07 08:05AM SCALE #1
-888.8888
Mode
Units
End
Select
Enter Truck ID
Scale
#1
Truck
Customer
Product
Project
Gross Tare Net
Note
Cancel Customer
10/22/07 08:05AM SCALE #1
-888.8888
Mode
Units
Complete
Scale
#1
Truck
Tare Gross
Customer
Product
Net
Project Product
Project