ProgressiveRC 10XP FMA Cellpro - Manual (Page 35)

Troubleshooting
There ar
o a charger! After the START/STOP button is
ressed, a special battery checking sequence automatically checks every wire before initiating a charge.
issue.
ages in the display. To determine the problem, look up the description
below
Me
e 26 ways to improperly connect two packs t
p
It is possible to get an unrelated safety code from a simple wiring
Operating errors appear as mess
. Correct the error. If errors continue, contact FMA Customer Service.
ssage Problem
Neg
Supply < 10
Su
Supp
n or thin wiring
Ch
Chg.
Cell is too high
A pack was detected on channel 2 after starting charge
Se ers on a series pack.
Low Voltage Cell
Ce
Reve
Check pack wiring
No
Ch2
n’t identify the pack. Check for correct node setting.
. Loose input connections.
Check pack wiring
Check pack wiring or dirty connectors
Un ge on the node connector.
Ch
Charge Timeout The pack is taking too long to charge
Bad Amps Setting Charger safety check
Amps Not Raising Check the banana wiring
Bad Fuel Table # Corrupted preset. Factory restore the charger
Bad Lith Fuel Tb Corrupted preset. Factory restore the charger
A123 < 2.7V/CELL Cell low voltage
A123 > 3.8V/CELL Cell high voltage
Options Corrupt Factory restore the charger
L.Supply V.Limit The supply voltage reached the cutoff
No Auto Amps Auto amps are not allowed in some chemistries
Chem Not Found Corrupted preset. Factory restore the charger
LIPO < 3.0V/CELL Cell low voltage
LIPO > 4.2V/CELL Cell high voltage
Set Amps >= 2A Lower the amps setting
Bad Banana Tot V Check the connectors. Clean the connectors.
Preset is Blank Change presets or factory restore
No Fuel Table Corrupted preset. Factory restore the charger
. Term. < 0V Check pack wiring
Volts Input supply voltage is too low
pply > 32 Volts Input supply voltage is too high
ly Unstable Check for a loose supply connectio
2 No Add Up Check pack wiring or dirty connectors
Overvoltage
C2 Pack Detected
ries Chargers Check Pack wiring. Check for 2 charg
A cell is too low
ll < 0.1V The cell voltage is too low on a cell
rse Polarity
de 10 < 0V Check pack wiring
Bad S. Count Channel 2 could
System Softstart Check the power supply is big enough
2 Pack Con. Err.
Ch1 No Add Up
balanced Only Unbalanced charge detected volta
1 has no pack Check pack wiring or dirty connectors
Positive < 0V Check bananas
Butt Not Pressed The confirm chemistry mode button was not pressed
Pack Detect CH1 Unbalanced charge detected voltage on the node connector
Pack Detect CH2 Unbalanced charge detected voltage on the node connector
35