ProgressiveRC 10XP FMA Cellpro - Manual (Page 34)

Quick start for the Cellpro 10XP Charger
Refer to m r complete operating details. anual fo
. Connect pack(s) to cha
Plug pack’s balance ht side of the charger (use balance
connector adapters a
rging only
outermost
arging two d plug
wires from
unba n accordance with bullet
. Configure charger:
To review selected preset’s settings: Press MODE button.
To select a different ODE button until you see the desired preset’s name and
display.
mistry and/or
/STOP b
button for one second.
. The charger will autom initiate a series of beeps when charging is
complete.
G. To end charging sessio
A. Connect charger to a 12V to 32V (maximum) power source.
B rger.
connector(s) into channel jack(s) on rig
s needed).
When cha one pack, plug pack’s balance connector into Ch1. Plug pack’s discharge
wires into banana jacks on charger’s panel.
packs: Plug discharge wires fro When ch m Ch1 pack into banana jack pair #1, an
discharge Ch2 pack into banana jack pair #2.
When using an lanced preset, connect only the pack discharge wires i
points 2 and 3 above.
C
preset: Press M
settings in
To change selected preset’s settings: Press and hold MODE button to set che
charge current. Press and hold to exit.
D. Press START utton for one second to begin charging.
E. During charging:
To view charge data: Press MODE button repeatedly.
To cancel charging at any time: Press START/STOP
F atically stop charging,
n and return to Preset Menu, press START/STOP button for one second.
and
34