Mercedes-Benz E-Coupe 2011 COMAND Manual - Manual (Page 93)

Map information in the display
Showing text information
During route guidance, you can have map
information displayed at the bottom edge of
the display.
X To show the menu: press W the COMAND
controller.
X Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Text Information On Map and
press W to confirm.
A # dot indicates the current setting.
X Select Arrival Time / Distance ,
Current Street , Geo-coordinates or
None and press W to confirm.
X To exit the menu: slide XVY the COMAND
controller.
Arrival time/distance to the destination
Arrival time/distance display switched on
:
Icon for destination
; Distance to the destination
= Icon for estimated time of arrival
? Estimated time of arrival
You can only see this display during route
guidance. While scrolling the map
(
Y
page 61), you will see additional data, e.g.
road names, depending on the crosshair
position, if the digital map supports this data.
i During route calculation, or if the vehicle
is traveling on a non-digitized road, the
linear distance to the destination is shown.
In this case, the display will be grayed out.
Road display
Road display active
:
Road names or numbers, e.g. for
highways
Geo-coordinate display
Geo-coordinate display active
:
Current height above average sea level,
rounded
; Current vehicle position: latitude
coordinates
= Current vehicle position: longitude
coordinates
? Number of GPS satellites currently being
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
Map operation and settings
91
Na
vigation
system
Z