Serial port mode sdo, Flow control sdo, Redirection after bios post sdo – Kontron CP307-V BIOS User Manual
Page 53: Serial port mode, Flow control, Redirection after bios post
CP307/CP307-V BIOS Guide
Advanced Setup
ID 35978, Rev. 2.0
Page 43
P R E L I M I N A R Y
Serial Port Mode
SDO
This function is used to select the baud rate (transmitted bits per second) of the serial port for
console redirection.
Note:
This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: 115200 8,n,1
Flow Control
SDO
This function is used to select the flow control for console redirection.
Note:
This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: None
Redirection After BIOS POST
SDO
This function is used to select redirection after BIOS POST.
Note:
This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: Always
SETTING
DESCRIPTION
115200 8,n,1
Use this setting to select 115200 as the baud rate of the serial port.
57600 8,n,1
Use this setting to select 57600 as the baud rate of the serial port.
38400 8,n,1
Use this setting to select 38400 as the baud rate of the serial port.
19200 8,n,1
Use this setting to select 19200 as the baud rate of the serial port.
09600 8,n,1
Use this setting to select 09600 as the baud rate of the serial port.
SETTING
DESCRIPTION
None
Use this setting to deactivate flow control.
Hardware
Use this setting to select the flow control by hardware.
Software
Use this setting to select the flow control by software.
SETTING
DESCRIPTION
Disabled
Use this setting to turn off the redirection after POST.
BootLoader
Use this setting to activate the redirection during POST and during BootLoader.
Always
Use this setting to specify that the redirection is always active.