Kontron CP307-V BIOS - Manual (Page 28)

Advanced Setup CP307/CP307-V BIOS Guide
Page 18 ID 35978, Rev. 2.0
P R E L I M I N A R Y
Legacy IDE Channels
This function controls the configuration of the available device channels within the legacy com-
patible IDE controller device.
Note: This function is only available when the IDE Configuration is set to Compatible.
Optimal and Fail-Safe default settings: SATA Pri, PATA Sec
Configure SATA as
This function controls the SATA controller device's operating mode.
Optimal and Fail-Safe default settings when the Configuration is set to Enhanced: IDE
Optimal and Fail-Safe default settings when the Configuration is set to PATA only: Disabled
SETTING DESCRIPTION
SATA Only Use this setting to specify the onboard SATA connector (SATA0) as the primary master,
the daughterboard connector (SATA2) as the secondary master, the RIO-1 channel
(SATA1) as the primary slave, and the RIO-2 channel (SATA3) as the secondary slave.
PATA Pri, SATA Sec Use this setting to specify the PATA channel as the primary channel, the RIO-1 SATA
channel (SATA1) as the secondary master, and the RIO-2 (SATA3) as the secondary
slave.
SATA Pri, PATA Sec Use this setting to specify the onboard SATA connector as the primary master, the
daughterboard SATA connector as the primary slave and the PATA channel as the sec-
ondary channel.
PATA Only Use this setting to specify the PATA channel as the primary channel. With this setting,
all SATA connectors are disabled by default.
SETTING DESCRIPTION
Disabled Use this setting to disable the SATA controller.
IDE Use this setting to allow the SATA controller to operate as a legacy IDE controller. In this
case, old IDE drivers can be used.
RAID Use this setting to allow the SATA controller to operate as a RAID controller.
AHCI Use this setting to allow the SATA controller to operate as an AHCI controller. In this case,
AHCI drivers must be used.