Kontron CP307-V BIOS - Manual (Page 125)

CP307/CP307-V BIOS Guide POST Codes
ID 35978, Rev. 2.0 Page 115
P R E L I M I N A R Y
DIM Code Checkpoints
The Device Initialization Manager module gets control at various times during BIOS POST to
initialize different BUSes. The following table describes the main checkpoints where the DIM
module is accessed:
CHECKPOI
NT
DESCRIPTION
2A Initialize different buses and perform the following functions: Reset, Detect, and Disable (function
0); Static Device Initialization (function 1); Boot Output Device Initialization (function 2). Function
0 disables all device nodes, PCI devices, and PnP ISA cards. It also assigns PCI bus numbers.
Function 1 initializes all static devices that include manual configured onboard peripherals, mem-
ory and I/O decode windows in PCI-PCI bridges, and noncompliant PCI devices. Static resources
are also reserved. Function 2 searches for and initializes any PnP, PCI, or AGP video devices.
38 Initialize different buses and perform the following functions: Boot Input Device Initialization
(function 3); IPL Device Initialization (function 4); General Device Initialization (function 5). Func-
tion 3 searches for and configures PCI input devices and detects if system has standard key-
board controller. Function 4 searches for and configures all PnP and PCI boot devices. Function 5
configures all onboard peripherals that are set to an automatic configuration and configures all
remaining PnP and PCI devices.