Cp307/cp307-v front / rear config screen, Vga connector sdo, Cp307/cp307-v front/rear config screen – Kontron CP307-V BIOS User Manual
Page 103: Vga connector
CP307/CP307-V BIOS Guide
OEM Feature
ID 35978, Rev. 2.0
Page 93
P R E L I M I N A R Y
CP307/CP307-V FRONT/REAR CONFIG SCREEN
This screen provides functions for specifying the CP307/CP307-V Front/Rear configuration
settings.
VGA Connector
SDO
This function is used to select the VGA connector routing.
Warning! Do not route the VGA connector to rear I/O if there is no rear I/O module installed!
Failure to comply with the instruction above will cause the monitor to display a blank
screen and may result in damage to the board. If this occurs, contact Kontron’s
Technical Support for further assistance.
Optimal and Fail-Safe default settings: Front
SETTING
DESCRIPTION
Disabled
Use this setting to disable the VGA connector. This does not include the VGA device.
Auto
Use this setting to allow the BIOS to automatically detect where a monitor is installed.
Front
Use this setting to specify that only the front connector is usable.
Rear
SEE WARNING ABOVE!
Use this setting to specify that VGA is routed to rear I/O.