Kontron AT8242 - Manual (Page 39)

23 AT8242
www.kontron.com
3.5.1 Installing the Board in the Chassis
To install a board in a chassis:
1 Remove the filler panel of the slot or see "Removing the Board" below.
2 Ensure the board is configured properly.
3 Carefully align the PCB edges in the bottom and top card guide.
4 Insert the board in the system until it makes contact with the backplane connectors.
5 Using both ejector handles, engage the board in the backplane connectors until both ejectors are locked.
6 Fasten screws at the top and bottom of the faceplate.
3.5.2 Removing the Board
If you would like to remove a card from your chassis please follow carefully these steps:
1 Unscrew the top and the bottom screw of the front panel.
2 Unlock the lower handle latch. Depending on software state, this may initiate a clean shutdown of the
operating system.
3 Wait until the blue LED is fully ON, indicating that the hot swap sequence has completed and board is
ready for removal.
4 Use both ejectors to disengage the board from the backplane.
5 Pull the board out of the chassis.
3.5.3 Installing the RTM
To install the RTM:
1 Remove the filler panel of the slot.
2 Ensure the board is configured properly.
3 Carefully align the PCB edges in the bottom and top card guide.
4 Insert the board in the system until it makes contact with the processor board.
5 Using both ejector handles, engage the board in the processor board connectors until both ejectors are
locked.
6 Fasten screws at the top and bottom of the faceplate.