Kontron CP383 - Manual (Page 59)

CP383 Configuration
ID 27784, Rev. 01 © 2004 Kontron Modular Computers GmbH Page 4 - 13
27784
.01.VC.040308/162544
P R E L I M I N A R Y
4.4.7 Writing Output Data
Table 4-12: Output Data Register
BITS TYPE DEFAULT FUNCTION
31-8 r/w 0 Reserved
7-0 r/w 0 Data, 8-bit digit
Note ...
Output data is 8 bit (each cluster); this register is read/write enable.
Table 4-13: Output Control Register
BITS TYPE DEFAULT FUNCTION
31-2 r/w 0 Reserved
1 r/w 0 irqen
0 r/w 1 Reset
Note ...
irqen is for diagnostic issuing an interrupt.
The reset bit should be set to 0 to activate a cluster.
Table 4-14: Output Status Register
BITS TYPE DEFAULT FUNCTION
31 r 0 Fail
30 r 0 Diag
29-0 r 0 Reserved
Note ...
The Diag status flag is the diagnostic bit from the HSD switch; Fail is the latched
diag status flag.