EFCO 945 Series - Manual (Page 25)

INSTALL 1ST
(AFTER SUBSILL)
[FIG. 22]
STEP 2) SUBSILL INSTALLATION AT DOOR OPENING
Where a door opening is required, use the equation in Figure 22. Install the subsill in
the same manner as illustrated on Pages 13 through 20, leaving the appropriate
clearance in the subsill for all door framing. End dams are not required at the door
frame end of the subsill. See Figure 23 on Page 24 for subsill sealant requirements at
door framing.
BAB 11/2000
SECTION VII - DOOR FRAME INSTALLATION
STEP 1) GENERAL NOTES
If a door opening is required, the subsill must be installed into the opening from the door
framing, ensuring that the appropriate clearance is available for the door frame. All
subsequent ladders must be installed from the door jamb out.
PAGE 23
1 3/16"
SUBFRAME CLEARANCE HOLE =
[DOOR OPENING WIDTH + 2 3/8"]
1 3/16"