EFCO S5600 Inside Glazed User Manual
Page 8

EFCO CORPORATION 6/2012 PART NO. Y304
Page 8 of 29
Series 5600 Inside Glazed Installation Instructions
Section IV: Perimeter Application
Determine Installation Method
A.)
Two types of perimeter applications are possible, including “F” perimeter anchors
or mullion anchors with continuous pressure plate pocket fillers. “F” perimeter
anchors should only be used in small “punched” openings that can be assembled
on the floor and set into the opening. Mullion anchors are generally used in
situations where mullions are erected one at a time, in sequence with
corresponding horizontals. Regardless of the installation method selected, the
remaining installation instructions are consistent between the two systems.
Perimeter with Continuous “F” Extrusion
Perimeter with Continuous Pressure Plate Pocket Filler
Fill gasket raceway in top and bottom of
each vertical mullion with sealant to
marry with perimeter sealant
*Note: Perimeter caulking of the primary
seal must be done prior to glazing
when using this application.
See approved shop
drawings for dimension
Cosmetic seal if desired
Pressure plate with return
Continuous “F” clip perimeter
(1/4” shim as required)
Critical Seal Line
Dense preset gasket
Primary seal required
Critical Seal Line
Bed inside corner with sealant
prior to mullion installation
Continuous bead of
sealant in three places
Sealant