Dynojet 198: Kart and ATV Dynamometers - Manual (Page 33)

Document #98234100 3 - 9
Motorcycle Carriage Contents
Motorcycle Carriage
Outrigger
Hardware Pack:
4 - 3/8" x 2
1/
2" Hex bolts
8 - 3/8" Flat washers
4 - 3/8" Nylon Lock Nuts
Motorcycle Carriage Installation
Step 1
Remove the 5/8" nut and washer from the
Outrigger Stud under the left or starter side front
deck. (There is also a round pipe shim and
washer on the stud.) Slide the Outrigger over the
pipe shim and up to the washer. Secure using the
5/
8" nut and washer, previously removed.