Dynojet 198: Kart and ATV Dynamometers - Manual (Page 16)

1 - 12 Document #98234100
Step 3
Use the Set Tool to expand the base of the
anchors. Place the small end of the Set Tool into
the threaded end of the anchor (threaded end
should be up). Drive the Set Tool with a large
hammer until the anchor is fully seated.
Step 4
Replace the (4) feet on the dyno and secure them
to the floor with supplied 3/8” hardware.
Set Tool
Height Adjuster
Bolt
Note: Level the Dynamometer frame by
adjusting the bolts that run through the
feet and into the frame.