Dynojet 198: Kart and ATV Dynamometers - Manual (Page 29)

Document #98234100 3 - 5
Step 3
Loosen the (6) screws that hold the top plate on
the dyno. This will allow you to lineup the holes.
and ease installation.
Step 4
Place the Rear Deck on the three supports so that
the silver tie-down hooks are away from the dyno
and the lip deck plate is resting on the dyno. Line
up the holes in the dyno frame with the holes in
the deck plate and loosely fasten the deck to the
dyno, using Rear Deck Hardware Pack C.