Dynojet 198: Kart and ATV Dynamometers - Manual (Page 31)

Document #98234100 3 - 7
Step 7
Bolt the two “U” supports to the lower Front
Deck Supports. (Front Deck Hardware Pack A)
Step 8
There is a right and a left Front Deck. The Deck
that has a bolt and bracket welded to the
underside is the LEFT and goes on the starter side
of the dyno. (This is for the carriage and
outrigger option) Place the Front Decks up to the
dyno so that the lip of the deck plate is resting on
the dyno. Line up the two holes on the lip of the
deck with the holes in the dyno and loosely bolt
the decks to the dyno, using the Front Deck
Hardware Pack C.