Tools required, Fastener table – Detex V40 ER User Manual
Page 3
Pencil
Hack Saw
Hammer
Tools Required
Used on Mounting plate and Endcap Mounting Holes
Recommended on Fire Rated Wood and
Used on Strike Hook Mounting Holes
Recommended on Fire Rated Wood and
Unreinforced Hollow Metal Doors
Unreinforced Hollow Metal Doors
3/8" Exterior Door Face
9/32" Interior Door Face
5/16" Exterior Door Face
13/64" Interior Door Face
----
----
----
----
-----
-----
-----
-----
PPH
No pilot hole necessary for
self-drilling screws
#10-32
#1/4-20
Sex Nut
Power Drill
Safety Glasses
Used to Fasten Centercase Unit onto Mounting plate
Use Either Machine Screws, Sheetmetal Screws,
Used to Mount Centercase Cover and Endcap
Used on 99 Strike Center Mounting Hole
Used on 98 Strike Shield Mounting Holes
or Sex Nuts
Comments
Used on Strike, Mounting plate, and Endcap Mounting Holes
Fastener Table
#7 or 13/64"
#36 or 7/64
#25 or 9/64"
-----
PPH
PPH
PPH
PPH
-----
-----
-----
#1/4-20 Tap
#10-24 Tap
#6-32 Tap
Drill Bit
Tap Wrench
Note: (1) Fastener selection will vary per catalog configuration and kits ordered.
(2) Mortise cylinder NOT provided.
Machine Screws
#6-32 x 3/8"
#1/4-20 x 1"
#10-24 x 5/8"
#1/4-20 x 1/4"
#6-32 x 5/8"
Level
Screw Driver
Used on Mounting plate and Endcap Mounting Holes
PPH
Sheetmetal Screws
PFH
#6 x 1"
#10 x 1"
#14 x 1"
PFH
Used on 98 Strike Shield Mounting Holes
Used on 99 Strike Center Mounting Hole
-----
9/64"
-----
-----
Metal Applications
Self-drilling Screws
#14 x 1-1/2"
Used on Strike
(3) For wood applications use Wood Door Kit, p/n 103991(supplied separately).
Tape Measure
103104 Page 3
Center Punch