Chapter 5.2.1 – AVer NXU Lite User Manual
Page 168
160
Name
Function
(12)Snapshot
Capture and save the screen shot either in *.jpg or *.bmp format.
(13) Event log
Show the record of activities that take place in the system. To filter the
records, select and click the option button to only display Event, System,
Operation, or Network.
(14) Auto Scan
Start/Stop video screen cycle switch
(15) Full screen
Use the entire area of the screen to only display the video.
To return, Right click the mouse or press ESC on the keyboard.
(16) Alarm
Alert and display warning info. Only Administrator-level can reset and turn
on, off and trigger the Sensor and Relay by right-clicking the item in the
Sensor and Relay list.
(17) De-interlace
To enhance the video quality. Set the de-interlace mode to #1, if you are
capturing motionless picture and #2, if it captures lots of movement.
i
IP camera doesn’t support de-interlace.
(18) Turbo
To improve the smoothness of live video. The default is enabled(
), but in
following situation:
- The channel is IP camera and is in 1 single screen.
- The channel is remote NVR and is in 1 single screen.
- The channel is analog camera, in 1 single screen, and decoding way is
software decode
Turbo function setup is in depended for each channel. To turn off turbo
function (
), click turbo button.
[Note] In multiple split screen mode, the turbo button is gray out.
(19) Watermark
To verify the playback video has not been modified (also see
(20) DirectDraw
Enhance the video quality.
i
Not all graphic cards can support this function.