AVer SEB3104H - Manual (Page 40)

34
3.2.2 Motion and Mask Setting
Click Default will back to the factory default value.
(1)
(2)
(3)
(4)
(1) Select Camera
Select the camera number you want to configure. To select all cameras, mark Select All check box.
(2) Motion Area
Enable/disable the motion detection and motion area setup.
- Enable: Enable/disable motion detection.
- Sensitivity: Set the sensitivity level of motion detector. The higher the value, the finer the
sensitivity is detected.
- Motion Area: Mark an area on the screen to regard the motion detects in the marked area.
Use the mouse drag from up to down to select a motion mask area. To un-select the mask
area, click Clear button.
(3) Video Shield
Video shield covers an area on the screen and the covered area would not be visible on the screen
and recorded.
- Video Shield Enable: Enable/disable video shield function.