AVer SEB3104H User Manual

Page 35

(3) Network
When user selects Static IP as a network type, please fill in the following information to make
network works.

IP: Assign a constant IP address which a real IP address gives from ISP to DVR system.

Mask: It is a bitmask used to identify the sub network and how many bits provide room for
host addresses. Enter the subnet mask of the IP address which user has assigned to DVR
system.

Gateway: A network device acts as a passageway to internet. Enter the network gateway IP
address.

DNS: Domain Name Server translates domain names (such as www.abb.com.tw) to IP
addresses. Enter the IP address of DNS if it is available.

Server Port: Fill in the port number that is using for WebViewer connection. Default is 80.

ISP Port: Fill in the port number that is using for remote updating firmware. Default is 5005.

(4) Other

Dynamic DNS: Dynamic Domain Name Service is a data query service mainly used on the

Internet for translating domain names into Internet addresses. Users can register their own

domain name on

http://ddns.avers.com.tw

(See

Appendix A

). Click Detail to configure the

DDNS function.

 DDNS Server Name: Select your DDNS server. The default only has one DDNS server

now. It may provide more DDNS in future.

 DDNS Domain Name: Enter the domain name that user has registered.
 Password: A password use to access DDNS that user has setup when register the

domain name

Network Time Synchronization: Adjust the DVR system time according to network time

server. Click Detail to configure the NTP function. In NTP window, fill in the IP address or

domain name in Time Server column and select the Time Zone. And then, clicks SYNC.

button to start adjust system time from network server.

(5)PPPOE ID and PPPOE Password
Fill the PPPOE ID and PPPOE Password that provides from your ISP for PPPOE connection
authentication. After entered ID and password, click OK and go to Status window to find out the IP