Canon EOS 650 - Manual (Page 45)

Shutter:
Vertical-travel focal plane shutter with soft-touch
electromagnetic release. All speeds electronically
controlled.
Shutter Speed:
EOS 650—1/2000—30 secs and bulb. X-sync is
1/125 sec. Can be set in 1/2-step in­
crements.
EOS 620—1/4000—30 secs and bulb. X-sync is
1/250 sec. Can be set in 1/2-step in­
crements.
Self-timer:
Electronically controlled with a delay of approx.
10 secs indicated by blinking LED operation confir­
mation lamp.
Film Loading:
After film positioning and back cover closure, the.
film automatically advances to the first usable
frame and then stops (approx. 1.5 secs)
Film Wind:
Automatic using the built-in miniature motor. Con­
firmation by the film transport bar marks in the
display panel.
Film Winding Mode:
Two selectable modes; S (single exposure) and C
(continuous exposure at the maximum speed of
approx, three frames per second).
Film Rewind:
Automatic using the built-in miniature motor.
Starts when the film end is reached and then
stops (with 24-exp. film, approx. 10 secs with the
EOS 650 and approx. 7 secs with the EOS 620).
Mid-roll rewind performed by pressing the film
rewind button.
Flash Contact:
Coupled directly to the camera by X-sync contact
on the accessory shoe.
Automatic Flash (using the Speedlite 420EZ/
300EZ with the camera set to “P”):
A-TTL flash auto-Using the camera’s A-TTL pro­
gram and the flash’s near-infrared preflash, the
correct aperture value is automatically set. X-
sync speed is also automatically set between
1/60 and 1/125 sec with the EOS 650 and bet­
ween 1/60 and 1/250 sec with the EOS 620 upon
flash charge completion. TTL control system
which meters the light reflected from the film
surface. Automatic fill-in flash is possible.
Grip:
Interchangeable.
The GR30 (without remote control terminal) is
standard with the EOS 650.
The GR20 (with remote control terminal) is stan­
dard with the EOS 620.
The large-size. Grip GR10 is available optionally.
84
Depth-of-Field Check:
By pressing the depth-of-field check button.
LCD Display Panel:
Displays only the information required at the time,
e.g. shooting mode, film winding mode, AF mode,
shutter speed, aperture value, film speed, or bat­
tery check. Timer function for eight secs is pro­
vided; the display is held on for eight secs after
the switch i.e., shutter button is pressed. The EOS
620’s display panel can be illuminated by electro­
luminescence.
Power Source:
One, six-volt lithium battery pack (2CR5). Battery
is replaced by removing grip.
Battery Check:
By pressing the battery check button. Three
energy levels are shown by the battery check bar
marks in the display panel.
Back Cover:
Interchangeable. Opened by sliding the latch with
safety lock. Quartz Date Back E and Technical
Back E can be attached.
Dimensions: 148(W) x 108.3(H) x 67.5(D) mm
(5-13/16" X 4-1/4" X 2-5/8")
Weight: EOS650—660g (23-5/16 oz.) body only
EOS620—700g (24-11/16 oz.) body only
(All data are based on Canon’s Standard Test
Method.)
Subject to change without notice.
This equipment has been tested and found
to comply with the limits for a Class B com­
puting device In accordance with the
specifications set forth in Subpart J of Part
15 of the FCC Rules. If this equipment does
cause interference to radio or television
reception which can be determined by turn­
ing the equipment on and off, use the equip­
ment in another location. If necessary, the
user should consult the dealer or an ex­
perienced radio/television technician for ad­
ditional suggestions. The user may find the
following booklet prepared by the Federal
Communications Commission helpful:
“How to Identify and Resolve Radio-TV in­
terference Problems"
This booklet is available from the US
Government Printing Office, Washington,
D.C., 20402, Stock No. 004-000-00345-4."
85