Canon EOS 650 - Manual (Page 27)

7. Auto Exposure Bracketing (EOS 620 Only)
Use auto exposure bracketing when you want
to choose the best exposure by changing the
amount of exposure on film intentionally. The
range of bracketing is up to ±5 steps in
1/2-step increments.
0i! AF SC-0 c
0
•'ISO'# <
'----------AEB-
1) Open the switch cover and press both the
AF mode selector and battery check button
simultaneously to display the 0.0 and
“AEB” indicating auto exposure brack­
eting.
• Once the buttons are depressed, you
can remove your fingers because the
“AEB” display is held on for approx­
imately eight seconds. To clear this
status within eight seconds, press the
shooting mode selector.
48
2) Turn the electronic input dial to the desired
.bracketing value.
• If you set 1.5 in the display panel, for ex­
ample, the camera automatically makes
three continuous exposures in se­
quence of -1.5 step of underexposure,
correct exposure according to the
camera’s
meter and +1.5 step of
overexposure. Then the auto exposure
bracketing status automatically clears.
Notes
1. Three continuous exposures are auto­
matically made regardless of the film wind­
ing mode.
f C
i.J
(S)
2. The original focus remains locked during
three continuous exposures regardless of
the AF mode.
3. To clear auto exposure bracketing before
shooting, display the “AEB” and preset
bracket value again by following step 1)
above, then turn the electronic input dial
until the bracket value returns to 0.0. (Clear­
ing auto exposure bracketing is impossible
while shooting.)
4. Bulb cannot be used with auto exposure
bracketing.
5. Auto exposure bracketing is impossible
with a flash.
49