Canon Rebel T2 300X - Manual (Page 53)

• Shutter
Type........................................ Eleclronically conlrolled focal-plane shutter
Shutter speeds........................ 1/4000 - 30 sec. in 1/2-slop Increments, bulb, X sync at 1/125 sec
Shutler release....................... Soft touch electromagnetic release (safety release lock possible)
Self-timer................................ Shool after 10 sec delay
Remote control..... ................ Remote Controller RC-1/RC-5 (DATE Model only)
• Flash
Built-in flash ,,,...................E-TTLII autoflash, FE lock possible
Guide No 13 (IS0100, in meters), 39 (ISO 100, in feet)
Recycling time: Approx. 2 sec.
Flash coverage: 28 mm lens angle covered
Red-eye reduction: Lamp
External EOS-dedicaled flash E-TTL II autoflash
« Film transport
Film loading,...........................Automatic prewind
Film advance modes.«,......... Single-lrame/conlinuous shooting
Continuous shooting speeds
(^prox.)-...,.„,„„-,.,«,.,„«...,._One Shot AF: 3 fps, Al Servo AF: 2 5 fps
Film r e w i n d , A u t o m a t i c Mid-roll rewind
• Custom Functions 6
• Date imprinting
(DATE Model only) .. „..Automatic calendar to 2099
• Power source............. T wo CR2 lithium batteries
• Dimensions (W
X H X
D). 130 x 90 x 64 mm/5 1 X 3 5 X 2 5 in
• Weight.............. ............365 g/12 7 oz (body only)
• All the specllicallons above are based on Canon's testing and measuring standards.
• Specifications and physical appearance are subject to change without notice.
This device complies with Part 15 of the FCC Rules Operation is subject to the following two
conditions: (1) This device may not cause harmful Interference, and (2) this device must accept
any Interference received. Including interference that may cause undesired operation
Do not make any changes or modifications to the equipment unless otherwise specified in the
instruction manual. If such changes or modifications should be made, you could be required to
stop operation of the equipment
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used In accordance with
the instruction manual, may cause harmful interference to radio communications
However, there Is no guarantee that interference will not occur in a particular installation If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and receiver
* Consult the dealer or an experienced radio/TV technician lor help.
Complies with the Canadian ICES-003 class B specifications
Respecte les exigences de la class B de la NMB-003 du Canada
C €
The CE Mark is a Directive conformity mark of the European Community (EC)
51