Canon AUTO ZOOM 1014 - Manual (Page 25)

4 Verify that the variable shutter control ring is set at "O"
(OPEN).
If it is not at "O", proper exposure cannot be obtained.
• When the variable shutter control lock button is rroved in the direction
of the arrow, the variable shutter control ring unlocks and may be turned
freely.
• The ring is locked by setting the index at the ’'O” position and
pushing the button in the opposite direaion of the arrow. The variable
shutter control lock indicator window turns orange to confirm it has been
locked. When the lock is released, it turns blue.
• Only three positions. O (OPEN). 2 and 4 may be locked. The others
cannot.
C Set the Exposure Adjustment Knob at on the Exposure
“ Adjustment Scale.
If the knob is not at "•" during ordinary electric eye operation, correct
exposure can not be obtained.
C Make sure that the Rewind Setting Indicator Turns Orange.
When the rewind setting indicator turns blue, press the rewind
mechanism cancellation button. This will have the same effect as when it is
orange. When the trigger is pulled and shooting continues, the rewind
setting indicator automatically turns blue.
(See the paragraph about the film rewinding button on page 23).
7 Check the Film Transport Indicator.
* Looking at the film transport indicator on the side of the body, pull
the trigger and run the film slightly. If the red and white lines move
smoothly, the film is driven properly.
You can also check by means of the film transport indicator lamp in the
viewfinder. If the lamp blinks, the film is driven properly. Otherwise,
remove the cartridge and load it again.