Canon AUTO ZOOM 1014 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

0 Checking the Batteries
^
If there is not enough voltage the camera does not work properly. It is
advisable to check the batteries occasionally.
•
Turn the switch dial to "R", push the battery check button and read the
needle in the check window.
•
When the needle points to the blue zone, the voltage is satisfactory and
you can use any shooting technique. When the needle is in the white zone,
the voltage is enough only to run the film at 18 fps. When the needle is in
the red zone, the voltage is too low and you should change the batteries.
With the needle in the red zone, even if the camera seems to work, the
voltage is not enough to operate the exposure system properly, so be sure
to change the batteries.
к
Eyepiece Adjustment
'
Look
into
the
viewfinder
while
directing
the
camera
to
a
bright
subject.
Loosen
the
tightening
screw
and
rotate
the
eyepiece
adjustment
ring till you can see the lines of the split image screen clearly in the center
of the viewfinder. Then, close the tightening screw.
•
Without
adjusting
the
eyepiece
to
your
individual
eyesight,
you
cannot
focus correctly.
•
The
microprism
rangefinder
can
be
interchanged
at
the Canon Slation
written on the iast page of this instruction booklet and the only charge will
be its actual cost.