Preparations for electric eye operation – Canon AUTO ZOOM 1014 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

C Loading the Film
“
• Open the rear cover by pushing the opening button.
•
Insert the film cartridge with the identification label facing the film type
window.
• Close the rear cover by pressing it to the former position.
When you hear a click the cover is locked.
FILM SPEED
The film speed is automatically set with the insertion of a film cartridge
and no manual adjustment is required.
The following film cartridges can be used.
Tungsten Type:
ASA
25
40
64
100
160
250
400
Daylight Type:
ASA
16
25
40
64
100
160
250
FOOTAGE COUNTER
The footage counter turns according to the length of exposed film. One
mark equals 2 ft. The counter returns automatically to "0" when the back
cover is opened.
• When the cartridge is out, the counter does not work.
FRAME COUNTER
One scale of the counter equals two frames of film. One full turn equals
72 frames (1 ft).
• To set the frame counter, rotate its knob and set the indication needle at
"0", so you can sea how many frames you have exposed.
Preparations for Electric Eye Operation
1 Set the switch dial at "R".
*
All the electric circuits are on and the shutter is ready to work.
"OFF” is the safety position at which the electric source is off to prevent
the shutter and the exposure meter from operating accidentally.
0
Make
sure
that
the
EE/manual
aperture
control
ring
is
^ pushed in.
•
If
the
EE/manual
aperture
control
ring
is
pulled
out,
the camera is
switched to manual operation and the EE exposure control does not work.