Casio XJ-360 - Manual (Page 6)

Projection Operations
6
Manually Selecting the Input Source
The procedure you should use to select the input source depends on whether you are using
projector keys or remote controller keys.
z To select the input source using projector keys, press the [INPUT] key on the projector to
cycle through input sources in the sequence shown below.
z To select the input source using remote controller keys, press the [RGB/COMPONENT],
[VIDEO], or [S-VIDEO] key on the remote controller to select the input source you want.
The currently selected input source name is shown in the upper right corner of the projection
screen.
z If the currently selected input source is not sending an input signal, the message “No
signal input” appears in place of the input source name.
z The input source name when RGB/Component is selected as the input source is
displayed as “RGB” or “Component” in accordance with the “Detailed Settings
J
Advanced Settings 2
J RGB Input” on the setup menu (page 44). For more information,
see the note under “Auto Input Source Selection” (page 5).
[Projector] [Remote Controller] [INPUT] key
[S-VIDEO] key
[VIDEO] key
[RGB/COMPONENT] key
(RGB/Component) (VIDEO) (S-VIDEO)