Model 113.248440 & 113.248510, All models, Tilting head for bevel cut – Craftsman 113.248510 User Manual

Page 35: Adjusting bevel lock knob

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MODEL 113.248440 & 113.248510

TILTING HEAD FOR BEVEL CUT

1. Unlock bevel lock by pulling out on knob located

under the left front edge of the table.

2. Turn handwheel counter-clockwise to increase

the tilt angle of the blade. The digital display will

read out the angle of the blade to the table.

3. Lock the bevel lock by pushing in on knob until it

is fully seated when desired bevel angle is
reached.

BEVEL LOCK LOCK

HANDWHEEL

ELECTRONIC DISPLAY

PANEL

ALL MODELS

ADJUSTING BEVEL LOCK KNOB

The bevel lock knob is factory adjusted and set. If
after repeated use it becomes necessary to adjust:

1. Pull the bevel lock toward and bevel the band

saw to 25 degrees.

2. Use a 9/16-inch wrench or socket to adjust the

locking nut behind the band saw mounting

frame. Turn nut clockwise to tighten.

3. Recheck bevel lock knob and readjust if neces

sary.

MOUNTING FRAME

BEVEL LOCK