Craftsman 113.248510 - Manual (Page 34)

location and function of controls
ALL MODELS
ON-OFF SWITCH
NOTE: The On-Off switch has a locking feature. This
feature is intended to help prevent unauthorized and
possibly hazardous use by children and others.
1. insert yellow key into switch.
2. To turn on, insert finger under end of red switch
lever and puli end out.
3. To turn off switch, push red lever in towards the
base.
4. WARNING: The locking feature provided is to
help prevent unauthorized use of your saw.
Always remove the yellow key and keep it in a
safe place. To remove yellow key, hold thumb on
the end of red lever to keep switch in “Off”
position and pull yellow key straight out.
MODEL 113.248210 & 113.248320
TILTING HEAD FOR BEVEL CUT
1. Unlock bevei lock by pulling out on knob located
under the left front edge of the table.
2. Turn handwheel counter-clockwise to increase
the tilt angle of the blade. The bevel scale printed
on the front cover shows the approximate angle
and is read at table level.
3. Lock the bevel lock by pushing in on knob until it
is fully seated when desired bevel angle is
reached.
BEVEL SCALE
BEVEL LOCK KNOB
HANDWHEEL
unnra
34