Sony DSC-F1 - Manual (Page 72)

Troubleshooting
Notes
• You can check the
simulation port number
and the port which the
infrared device is
installed: Double-click
the [Infrared Monitor]
icon in the Control
Panel and click the
Option tag.
• The hardware port
number and simulation
port number differ. Set
each port number
correctly.
An error occurs during infrared data transmission
• The WIRELESS setting of the Digital Still Camera is
not proper.
-> Select "ON" in the WIRELESS menu of the Digital
Still Camera, (page 22)
• The power of the Digital Still Camera is not turned
on or set to "CAMERA."
■> Set the POWER/Function dial of the Digital Still
Camera to "PLAY." (page 22)
• The infrared device or driver is not properly
installed.
-> Check to see if the infrared hardware is built in
your PC or an infrared adapter is properly
connected to the proper hardware port number.
-> Check to see if the infrared driver is installed in
the hard disk. You can check the driver by
opening the Option tag of the [Infrared Monitor]
in the Control Panel.
• The Serial Port in the Settings dialog box is not
properly assigned.
^ Assign the proper simulation port in the Infrared
Device Wizard, (page 20)
-> Check to see that the Serial Port in the Settings
dialog box of the "Sony Digital Still Camera
Album Utility" is properly assigned, (page 30)
• The infrared ports of the Digital Still Camera and the
PC are not properly oriented.
Place the two ports within the controllable area.
Remove an obstacle which may interrupt the
infrared communications, if any. Also check the
Status tag of the [Infrared Monitor] in the Control
Panel to see if the infrared device is detected.
(page 21)
72 others