Sony DSC-F1 - Manual (Page 21)

Notes
• Place the infrared ports
of the camera and PC
within the controllable
area. Do not place
them too far nor too
close, which may
interrupt transferring
or cause noises.
• Do not cover the
infrared ports with
your hand or any other
objects.
• Infrared rays cannot
pass through a wall,
opaque^lass, etc. If
they pass through
glass, etc., the
controllable distance
becomes short.
• Do not turn off the
power of the camera or
interfere with
communication during
transmitting the data,
which may cause a
transmission failure.
• We suggest you use the
Digital Still Camera
with the AC power
adapter.
• Also refer to the online
manual of the Infrared
Data Communications
Driver.
Uninstalling the software
When the software becomes unnecessary, remove all
the software files from your hard disk as follows:
1
Select [Add/Remove Programs] in the Control
Panel.
2
Select “Infrared Support for Windows 95 Version
2.0" in the [Add/Remove Programs Properties]
and double-click [Add/Remove].
4 Connecting the Digital Still Camera
Your PC
(D
3
to
c
■a
□ Place the infrared port located on the front panel of
the Digital Still Camera DSC-Fl and that of your PC
face to face so that you can transmit image data
from the camera to the PC or vice versa.
(Controllable area is about 4 - 1 2 inches (10-30 cm)
in terms of straight line distance and 15 degrees
right, left, up and down each in terms of conical
angle.)
□ Check the Status tag of the Infrared Monitor in the
Control Panel to see if the infrared device is
detected.
□ The figure above is an example of connecting the
Digital Still Camera with a PC with the built-in
infrared communications device. You can also use a
PC equipped with an infrared adapter.
continued
Settingup 21