Sony DSC-F1 - Manual (Page 19)

Connecting via infrared port
Important notice to
the users who have
installed the previous
version (Version 1.0)
of "Sony Digital Still
Camera Album
Utility"
Before installing the
Version 1.5 of the
software, make sure to
uninstall the Version
1.0 of the software
with the CD-ROM
supplied with the
Version 1.0.
Tip
You can check to see if
this driver software is
installed by opening the
Control Panel and looking
for "Infrared Monitor,"
Note
You need the infrared
communijation device to
use this driver software.
1 Installing "Sony Digital Still Camera
Album Utility" and "Sony DSC-F1
TWAIN 1.5"
To handle Digital Still Camera images on your PC,
use the installer to install "Sony Digital Still Camera
Album Utility" and "Sony DSC-Fl TWAIN 1.5." The
installation process is the same as that for connecting
via cable. Follow the steps explained in pages 14 and
15.
2 Installing "PhotoStudio"
To edit the Digital Still Camera images on your PC,
use the installer to install "PhotoStudio" onto your
hard disk. The installation process is the same as that
for connecting via cable. Follow the steps explained
in page 16.
3 Installing Microsoft Windows 95
Infrared Communications Driver
To perform infrared communications with the Digital
Still Camera, use the installer to install "Microsoft
Windows 95 Infrared Communications Driver
Version 2.0." Install this driver software if it is not
installed on the Windows 95 of your PC. You can use
this driver under Windows 95 only. When using
Window 3.1, do not install this driver.
Under Windows 95
1
Turn on your PC and start up Windows 95.
2
Insert the supplied CD-ROM into the CD-ROM
drive on your PC .
The [Sony DSC Setup] dialog box appears.
3
Click [Cancel].
The screen returns to Windows 95.
4
Click the [Start] button and then click [Run].
The [Run] dialog box appears.
continued
to
a>
Zl
to
c
■D
Setting up 19