Dell Vostro 1000 (Mid 2007) - Manual (Page 125)

Troubleshooting
125
I NSERT BOOTABLE MEDIA — The operating system is trying to boot to
nonbootable media, such as a floppy disk or CD. Insert bootable media.
I NVALID CONFIGURATION INFORMATION - PLEASE RUN S YSTEM S ETUP
P ROGRAM — The system configuration information does not match the
hardware configuration. The message is most likely to occur after a memory
module is installed. Correct the appropriate options in the system setup
program (see "Using the System Setup Program" on page 175).
K EYBOARD CLOCK LINE FAILURE — For external keyboards, check the cable
connection. Run the Keyboard Controller test in the Dell Diagnostics (see
"Dell Diagnostics" on page 111).
K EYBOARD CONTROLLER FAILURE — For external keyboards, check the cable
connection. Restart the computer, and avoid touching the keyboard or the
mouse during the boot routine. Run the Keyboard Controller test in the Dell
Diagnostics (see "Dell Diagnostics" on page 111).
K EYBOARD DATA LINE FAILURE — For external keyboards, check the cable
connection. Run the Keyboard Controller test in the Dell Diagnostics (see
"Dell Diagnostics" on page 111).
K EYBOARD STUCK KEY FAILURE — For external keyboards or keypads, check the
cable connection. Restart the computer, and avoid touching the keyboard or
keys during the boot routine. Run the Stuck Key test in the Dell Diagnostics
(see "Dell Diagnostics" on page 111).
L ICENSED CONTENT IS NOT ACCESSIBLE IN M EDIA D IRECT — Dell MediaDirect™
cannot verify the Digital Rights Management (DRM) restrictions on the file,
so the file cannot be played (see "Dell MediaDirect problems" on page 132).
M EMORY ADDRESS LINE FAILURE AT ADDRESS , READ VALUE EXPECTING VALUE —
A memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them (see "Memory" on page 95).
M EMORY ALLOCATION ERROR — The software you are attempting to run is
conflicting with the operating system, another program, or a utility. Shut
down the computer, wait 30 seconds, and then restart it. Try to run the
program again. If the error message still appears, see the software
documentation.
M EMORY DATA LINE FAILURE AT ADDRESS , READ VALUE EXPECTING VALUE — A
memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them (see "Memory" on page 95).
book.book Page 125 Friday, October 19, 2007 2:03 PM