Dell Vostro 1000 (Mid 2007) - Manual (Page 104)

104
Adding and Replacing Parts
b Release the Mini-Card by pushing the metal securing tabs toward the
back of the computer until the card pops up slightly.
c Lift the Mini-Card out of its system board connector.
NOTICE:
The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the card and on the system board, and realign
the card.
5 Install the replacement Mini-Card:
a Insert the Mini-Card connector into the system board connector at a
45-degree angle, and then press the other end of the Mini-Card down
into the securing tabs until the card clicks into place.
1 metal securing tab 2 Mini-Card 3 metal securing tab
2
3
1
book.book Page 104 Friday, October 19, 2007 2:03 PM