Dell 1710/n Mono Laser Printer User Manual
Page 97
You are using transparencies that do not meet the printer specifications.
The Form Type setting in the printer driver is set to something other than Transparency.
Try the following:
Use only transparencies recommended by the printer's manufacturer.
Make sure the Form Type setting is set to Transparency.
Toner specks appear on the page.
The toner cartridge is defective.
The fuser is worn or defective.
Toner is in the paper path.
Try the following:
Replace the toner cartridge. See
Replacing the Toner Cartridge
.
Replace the fuser
1
.
Call for service.
Toner rubs off the paper easily when you handle the sheets.
The Paper Texture setting is wrong for the type of paper or specialty media you are using.
The Paper Weight setting is wrong for the type of paper or specialty media you are using.
The fuser is worn or defective.
Try the following:
Change Paper Texture
2
from Normal to Smooth or Rough.
Change Paper Weight
2
from Plain to CardStock (or other appropriate weight).
Replace the fuser
1
.
Print density is uneven.
The toner cartridge is defective. Replace the toner cartridge. See
Replacing the Toner Cartridge
.
Ghost images appear on the page.
The Form Type setting in the printer driver is set incorrectly.
Toner level is low in the toner cartridge.
Try the following:
Make sure the Form Type setting is correct for the paper or specialty media you are using.
Replace the toner cartridge. See
Replacing the Toner Cartridge
.
Print only appears on one side of the page.
The toner cartridge is not properly installed. Remove and then reinsert the toner cartridge.
Margins are incorrect.
The Form Size setting in the printer driver is different than the size paper that is loaded in the
tray. Set the Form Size to the correct setting, and then reprint your job.
Print is skewed (inappropriately slanted).
The guides in the selected tray are not in the correct position for the paper size loaded in
the tray.
The manual feeder's guides are not in the correct position for the paper size loaded in the
feeder.