Dell POWEREDGE R710 - Manual (Page 40)

40
About Your System
BIOS Update
Attempt Failed!
Remote BIOS update
attempt failed. Retry the BIOS update. If
problem persists, see
"Getting Help."
Caution!
NVRAM_CLR jumper
is installed on
system board
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared. Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5). See
Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager."
CPU set to
minimum
frequency.
The processor speed may be
intentionally set lower for
power conservation. If not an intentional setting,
check any other system
messages for possible causes.
CPU x installed
with no memory.
Memory modules are
required but not installed in
the indicated processor’s
memory slots. Install memory modules for
the processor. See "System
Memory."
CPUs with
different cache
sizes detected.
Mismatched processors have
been installed in the system. Ensure that all processors
have the same cache size,
number of cores and logical
processors, and power rating.
Ensure that the processors
are properly installed. See
"Processors."
CPUs with
different core
sizes detected!
System halted
CPUs with
different
logical
processors
detected! System
halted
CPUs with
different power
rating detected!
System halted
Table 1-2. System Messages (continued)
Message Causes Corrective Actions