Dell PowerEdge C8000 - Manual (Page 183)

Installing System Components 183
4 Replace the screw securing the mezzanine card bridge board to the
bracket. See Figure 3-29.
5 Lower the 10 GbE mezzanine card assembly to the sled tray.
See Figure 3-28.
6 Replace the two screws securing the 10 GbE mezzanine card assembly to
the sled tray. See Figure 3-28.
7 Replace the front cover. See "Installing the Front Cover" on page 149.
8 Replace the sled. See "Installing a Sled" on page 144.
MicroSD Card Reader
Removing the MicroSD Card Reader
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 143.
2 Remove the front cover. See "Removing the Front Cover" on page 148.
3 If applicable, remove the RAID battery. See "Removing the RAID Battery"
on page 169
4 If applicable, remove the mezzanine card. See "Removing the Infiniband
Mezzanine Card" on page 176 or "Removing the 10 GbE Mezzanine Card"
on page 180.
5 If installed, remove the MicroSD card. Locate the MicroSD card slot in the
MicroSD card reader and press inward on the card to release it from the
slot and remove the card. See Figure 3-31.