Dell PowerEdge C8000 - Manual (Page 149)

Installing System Components 149
Figure 3-8. Removing and Installing the Front Cover
Installing the Front Cover
NOTE: It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
1 Check that all cable connections are secure.
2 Place the front cover on top of the sled tray, aligning the notches in the
front cover with the corresponding tabs in the sled tray. See Figure 3-8.
3 If an expansion card is installed, make sure the expansion card riser is
firmly seated.
4 Replace the four screws securing the front cover to the sled tray.
See Figure 3-8.
1 M3 screws (4) 2 front cover
1
2