Dell PowerEdge C5220 - Manual (Page 95)

Installing System Components 95
Figure 3-20. Removing a SAS Mezzanine Card
Installing a SAS Mezzanine Card with 3.5" HDD
Prior to installing a mezzanine card, you must first remove the sled board
from the chassis, see "Removing a Sled" on page 62.
1 Remove the mezzanine card from its static-proof packing.
2 Place the mezzanine card in the mezzanine bracket.
3 Secure the card on the bracket with the provided screws.
4 Insert the linking board into the mezzanine card as shown in the following
image.
5 Secure the linking board to the bracket with the provided screw.
6 With the PCIe connector facing up, attach the SATA cable 4 to the SAS
mezzanine card.
7 With the PCIe connector facing up, attach the SATA cable 5 to the SAS
mezzanine card.
5
3
6
4
3
6
7
6