Dell PowerEdge C5220 - Manual (Page 32)

32 Using the System Setup Program
Embedded SATA Link Rate Auto*
1.5 Gbps
3.0 Gbps
Auto is default mode.
Set SATA port to run on
GEN1 mode by selecting
1.5 Gbps.
NOTE: Function supported
after BIOS 2.0.X.
SATA Port 0/SSI Hard
drive 0
While entering setup,
BIOS auto detects the
presence of SATA devices
and displays the status of
detected SATA hard drives.
SATA Port1/SSI Hard
drive 1
While entering setup,
BIOS auto detects the
presence of SATA devices
and displays the status of
detected SATA hard drives.
SATA Port2/ Hard drive 0 While entering setup,
BIOS auto detects the
presence of SATA devices
and displays the status of
detected SATA hard drives.
SATA Port3/ Hard drive 1 While entering setup,
BIOS auto detects the
presence of SATA devices
and displays the status of
detected SATA hard drives.
SATA Port4/ Hard drive 2 While entering setup,
BIOS auto detects the
presence of SATA devices
and displays the status of
detected SATA hard drives.
SATA Port5/ Hard drive 3 While entering setup,
BIOS auto detects the
presence of SATA devices
and displays the status of
detected SATA hard drives.
Menu Fields Settings Comments