Dell PowerEdge C5220 - Manual (Page 47)

Using the System Setup Program 47
Serial Port Number COM1
COM2 as SOL* Serial port number
Serial Port Address 3F8h/2F8h*
2F8h/3F8h COM1/COM2 IO port
address
Flow Control None*
Hardware Flow control can prevent
data loss from buffer
overflow. When sending
data, if the receiving
buffers are full, a 'stop'
signal can be sent to stop
the data flow. Once the
buffers are empty, a 'start'
signal can be sent to re-
start the flow. Hardware
flow control uses two wires
to send start/stop signals.
Redirection After BIOS
POST
Disabled
Always* Redirection After BIOS
POST
Terminal Type ANSI*
VT100
VT-UTF8 Emulation: ANSI:
Extended ASCII char set.
VT100: ASCII char set.
VT-UTF8: Uses UTF8
encoding to map Unicode
chars onto 1 or more bytes.
VT-UTF8 Combo Key
Support
Disabled
Enabled* Enable VT-UTF8
combination key support
for ANSI/VT100 terminals.
NOTE: BIOS setup screens display at 100 (columns) x 31 (lines). Change the client-side
console utility settings to support 100 (columns) x 31 (lines) for accurate screen display.
Menu Fields Settings Comments