Bios error messages – Dell Serial Attached SCSI 6iR Integrated and Adapter User Manual
Page 54

52
Troubleshooting
BIOS Error Messages
Table 7-4.
BIOS Error Messages
Message
Meaning
Press
Enable BIOS
When the BIOS is disabled, you are given the option
to enable it by entering the configuration utility. You
can change the setting to Enabled in the
configuration utility.
Adapter at Baseport
xxxx is not
responding where xxxx
is the baseport of
the controller
If the controller does not respond for any reason but
is detected by the BIOS, it displays this warning and
continues. Shut down the system and try to reseat
the controller. If this message appears again, Contact
Dell.
Following SAS targets
are not responding...
When the BIOS determines that previously
configured physical disks are not connected to the
controller, the BIOS displays this warning and
continues to boot. The system continues to boot. See
"Physical Disk Related Issues" on page 50 for
troubleshooting tips.
Adapter configuration
may have changed,
reconfiguration is
recommended!
Press CTRL-C to run
Dell SAS 6
Configuration
Utility…
Start the Configuration Utility and confirm the
configuration of the SAS 6/iR controller.
Initializing...
Displays while the BIOS is waiting to initialize.
SAS discovery error
Indicates that there was a discovery error reported by
the firmware and may be accompanied by more such
messages. Enter the Configuration Utility to
investigate.
book.book Page 52 Monday, September 15, 2008 2:47 PM